When the Samsung cleaning machine presents a U6 mistake, it means the drum is out of equilibrium throughout a cycle. It would be extra precise to state that there is no U6 error code amongst the Samsung codes (presently of creating this short article!!!). This is a typical Ub error code.
Somehow, many individuals perplex the b letter with 6. Some sites explain the error as «the water degree sensor mistake». Still, neither handbooks, no the main internet site of the maker gives a description of this mistake code.
Why does the U6 mistake happen?
Generally, a modern Samsung washing maker will certainly try to balance the lots. If this does not function, it will by force stop the cleaning cycle as well as will certainly turn off. Or it will display the U6 mistake code. Additionally, it may stop rotating and also show the U6 error. Anyway, the garments will remain wet. The washing machine might revolve slowly if the load is rather well balanced for low rate. Then if the imbalance is still there, the washing machine won’t accelerate. So the laundry will be much wetter than it goes out after the normal spin cycle.
The washer can not stabilize the laundry load in the drum, if:
The things are bunched up or have actually got tangled;
You have little packed the washer: a couple of things are there;
You strained the washer.
The error code generally appears at the 9th, 7th or 3rd minute before the end of the cleaning cycle. Before the code is displayed, the drum turns gradually for a few minutes in both direction. It suggests the device attempts to balance the laundry load. The timer is paused.
How to avoid the u6 error
The very first point to do around this mistake is to check if the washing equipment is steady. Possibly during the previous washing as well as spin cycles, the washing equipment moved somewhat. So now one of the legs impends.
A small gap between the leg and also the flooring might raise the amplitude of drum resonances at broadband
How to level the cleaning maker Samsung
Next off, you need to examine the washing tons in the washing machine as well as the washing-spin mode:
The load | The reason for the error code to appear | Troubleshooting |
One or two items. | The washing machine can not rearrange the laundry evenly along the drum surface. The main load lies on only one section of the drum. | Load at least 3-4 items. |
One big (heavy) item and a few small (lightweight) laundry items. | Set the spin speed to 400 rpm or start the washing cycle without spin. | |
The loaded items are made of different fabrics. | Each type of fabric absorbs water differently. So the weight of the laundry items may differ, and the spin cycle won’t go properly. | Load the items made of similar fabrics. |
Bed linen. | During the washing cycle, the items get tangled or get in a duvet cover or a pillowcase. | Load no more than 2 kg of the linen at a time. Set the spin speed to 800 rpm. |
Overload. | If there is a lot of laundry in the washer, it is more difficult to spread it in the drum. | Only the “Cotton” mode allows the maximum load of the washing machine. See user manual to learn the right way to load the washer. |
Just How to Do Washing.
Nowadays you can acquire a Samsung cleaning machine with a huge drum. The ordinary drum is presently for a 6 kg lots. However you can buy a cleaning equipment where you can load 7, 8 or perhaps 10 kg of washing. Probably these washing machines are most likely to quit the spin if underloaded. Why? They need even more products to make the lots.
Occasionally unbalanced tons occur by coincidence: the washing machine spreads out the weight in a strange disorderly way. Yet, it is feasible to minimize both the threat of inequality as well as the amplitude of vibrations. Continuous unbalanced loads may trigger malfunctions of your cleaning device.
If the above techniques don’t help to balance the washer, after that one of the most likely reason is a technological problem. It might be the electric motor, the shaft of the drum, nuts, and gaskets.