|Model||Description||Software Model Number|
|DFUW, DUWC, VUWC||24 inch Wine Cellar||11|
|DFUR, DUAR, VUAR||24 inch Beverage Center||21|
|DFRD, DURD, VURD||24 inch Refrigerated Drawers||16|
Viking Refrigerator Diagnostic Information
Solution Diagnostics Mode permits you to identify the firmware and software program variations, test standing of «model particular» system elements and also sensing units, and also alter state of parts where applicable (i.e.— compressor on/off, etc.).
Enabling Solution Mode: To allow Service Mode, press and hold the «WARMER» switch while pushing the «COLDER» button four times within 5 seconds.
After getting in Solution Setting, the first number that you will certainly see indicates the software model number for the particular system you are servicing. For instance, if you are servicing a 24 inch wine cellar (DFUW, DUWC, VUWC), the very first number you will certainly see is 11. See graph listed below for equivalent model and software program referral.
The 2nd number you will certainly see suggests the software application version release. For example, if you see 44 on the display screen panel it shows software version 4.4.
While in Service Setting, press the «SET» switch to tip through Tests 0-9. The first digit of the display screen will certainly reveal the test number. The second figure indicates the current state of each part under test and also is shown as «1» being ON, CLOSED, or SHORTED as well as «0» being OFF or OPEN. Examinations 0 as well as 1 disclose an open or shorted condition identified at the sensing unit inputs. Tests 2 through 6 permit you to transform tons ON with the «WARMER» switch and also OFF with the «COLDER» switch. Tests 7 through 9 verify state adjustment of the door switches over and/or magnetic reed sensing unit. The component tests offered are explained in Available Element Examinations chart.
|PROBLEM||POSSIBLE CAUSE||WHAT TO DO|
|Refrigerator does not operate||Refrigerator is not plugged in||Plug in refrigerator.|
|Control is not on Fuse is blown, or circuit breaker needs to be reset||Properly adjust controls Replace blown fuses. Check circuit breaker and reset.|
|Power outage has occurred.||Call local power company to report outage|